Install the Paper Feed Tray
2
Quick
Setup
Before you can use your printer:
Steps 1 to 5 - Setup your printer.
Step 6 - Install the correct Interface cable for your system—USB or Parallel.
Step 7 - Determine your computer’s Operating System—Windows®95, 98, 2000, NT® 4.0 or
Macintosh® (OS 8.1 or higher), then install the correct printer software for your computer’s
Operating System and Interface.
Align tabs on bottom of paper tray
into slots on back of printer.
Swing tray up and align tabs
and slots at top.
Press to lock tray in place.
Remove the Protective Sheet
3
See the on-line User’s Guide for more information about your printer.
➋
Check Contents
1
➊
➊
Pull out sheet ➊, and remove tape ➋.
If transparent film is attached, remove
film with sheet.
Tilt up the image drum and lift it out. Do not
touch image drum’s green surface.
➌
Lift the cover.
Printer
Paper Feed Tray
➍
Toner
➎
Power Cord
CD
➏
Light-Shield Bag (to protect image
drum from light when it is removed
from printer)
➊
➋
➊
➐ Quick Setup Instructions
➐
Interface cable is not included. For
information on cable requirements, see
“Supplies” in the on-line User’s Guide.
!
Replace the image drum, tilting it down
to slide under the guides ➊.
Press down firmly until drum snaps into place.
58341901
©
2000 Oki Data Americas, Inc.
|